Single-side MGO Aluminum Honeycomb Board

The Single-side MGO Aluminum Honeycomb Board is a color-coated steel faced panel that combines one magnesium-oxide layer over an aluminum honeycomb core, hand-assembled. The design layers a hygienic, flat MGO face onto the lightweight rigid honeycomb structure, so the MGO supplies the smooth, cleanable surface a controlled room requires while the honeycomb core keeps the whole assembly light and dimensionally stiff. The result is an even, level panel that is lighter than a solid-core equivalent and resists warping across wide sheets. It is suitable for cleanroom walls, ceilings and partitions where both flatness and low dead load are required, and joints by male-female slot or aluminum center profile for a clean, level finish that stays light on the building frame, across the 50 to 100 mm thickness range. The MGO face wipes clean easily, and the honeycomb backing keeps the broad sheet flat without heaviness on the supporting structure. The MGO side gives a smooth, scrubbable hygienic face, while the cellular core resists flex between fixings, so the panel reads level on high walls and long ceilings with little joint work.

This is the balanced cleanroom panel: a single MGO skin supplies the smooth, durable hygienic face a cleanroom requires, while the honeycomb core keeps the whole assembly light and rigid - avoiding both the weight of a full cementitious panel and the lower surface quality of bare honeycomb. For hospitals, biotech and precision rooms where low structural load plus a clean, flat face matter, it gives a middle-weight solution rather than the heavier double-MGO build. The procurement benefit is a single board that satisfies the hygiene face and the light-structure budget at once, without over-specifying the double-sided version, which keeps the wall package lean and cost-controlled on a balanced cleanroom build that does not need the highest rigidity tier.